Cabin Hot Tub Instructions

Removing the cover

Please follow each step to easily remove the cover. Do not put the cover on the ground.

Unbuckle the cover from each of the 4 corners
Fold the left side of the cover over to the right
Slide the cover into the cover lifter (ensure the lift is pulled up as seen in photos)
Walk to the right side of the tub and push the cover downward to the side
Refer to the next section for turning on jets
When you're finished, reverse the steps to return cover to the top. This will ensure it stays properly heated and clean

Operating the jets

On the touchpad:

Press the jets button to turn on one set of jets
Press the aux button to turn on the other set of jets
There are dials around the tub to boost the jets with air bubbles
Adjust the temperature using the up or down arrows (Do not go over 103 degrees for safety reasons)
Bubble bath or other soaps/oils must not be used at all in the hot tub
Please leave the blue floating device in the tub to ensure correct water balance

Operating LED Lights & Bluetooth Speaker

Operating LED Lights & Bluetooth Audio

Press the light button to turn on the LED lights throughout the tub. Upon first press, the lights will fade through all of the colors. Each press after will toggle between one color at a time.

To connect your phone to the built-in Bluetooth speaker, connect to the JOYONWAY device and the code is 2288

Safety

Safety Rules

It is ideal to shower before using the hot tub to ensure the water remains clean
Do not bring glass in or near the hot tub
Elderly persons may need to consult their doctor prior to hot tub use
Pregnant women should consult with their doctor prior to hot tub use
It is highly recommended that children under the age of 5 should not use the hot tub for safety reasons. Other children must be supervised by adults at all times.
Do not enter if temperature is above 104 degrees
Try to limit soaks to 15 minutes at a time and allow time to cool off between soaks
Do not use any soaps or oils in the hot tub